QUICK INFO

For the following data to be available, your PBC-PRO must have been purchased with the OBD-II CAN BUS option and it has to be programmed with the special TFSI firmware.

To check if this is true go to menu 7.2 and you should see "TFSI" written at the last line of the screen. It also has to be connected to the OBD-II port.

LIST OF AVAILABLE PARAMETERS RETRIEVED FROM THE ECU

RPM                                                r/min        

- actual engine rpm from ecu

LAMBDA                                                l            

- actual lambda value from ecu

SPEED                                           Km/h    

- actual vehicle speed in km/h from ecu

vag ECT   degC                                         

- engine coolant temperature from ecu

vag AIT   degC                                               

- air intake temperature from ecu

vag  RETARD  1                                            

- Knock retard value for cylinder 1 from ecu

vag  RETARD 2                                            

- Knock retard value for cylinder 2 from ecu

vag  RETARD 3                                            

- Knock retard value for cylinder 3 from ecu

vag  RETARD 4                                            

- Knock retard value for cylinder 4 from ecu

vag  OILT  degC                                            

- oil temperature from ecu

vag  FPRESS  bar                                        

- fuel pressure from ecu

vag  TPS  %                                                  

- thottle position from ecu

vag  IGNITION                                              

- ignition angle from ecu

vag  MISFIRES                                            

- misfire counter from ecu

Hint:

Some TSI engines do not have a wideband lambda sensor,in that case the "LAMBDA: parameter will display the volts from the narrowband sensor.

If you need to connect an external wideband lambda you must connect it to analog input 1 and set it up in menu 5.6.